The QuBe IP Trunks module is used to connect the PBX to the SBC to allow the PBX to handle incoming and outgoing calls.

A trunk will automatically be created on creation of the QuBe PBX to connect with the SBC.

SIP Trunk: Set up the SIP trunk to your specifications.

• Click the Create SIP Trunk Button
• Trunk Name
  • Edit the trunk name if you wish to define it with a unique name
• Outbound CID
  • If the outbound CID is set in trunk module it will be universal to all outbound calls
• CID Options
  • CID options determine what outbound CID are allowed out from trunk
• Trunk Type
  • Set the trunk type of either peer or user. Default is peer
• Host
  • Host is the IP or DNS name of the SIP server
• DTMF Mode
  • RFC2833 sends DTMF tones separately with specially encoded RTP packets. These are distinct audio packets but are within the same network connection.
  • Inband sends tones as inband audio with the voice stream. Dialing on the device will create DTMF tones.
  • Info is an out of band method which sends the DTMF signals over SIP using a separate network connection
• NAT Settings
  • See extension page for explanation on NAT selection
• Direct Media
  • Set YES or NO depending on how to pass trunk media
• Qualify
  • Set YES or NO depending on how to enable peer qualifying
• From Domain
  • When making outbound SIP INVITEs to non-peers, use your primary domain “identity” for from: headers instead of just your IP address. This is to be polite and it may be a mandatory requirement for some destinations which do not have a prior account relationship with your server.
• Authenticate Insecure
  • Authenticate insecure notifies how to authenticate to the peer
• For additional SIP settings drop down the SIP Settings section
• Enter Dialed Number Manipulation Rules so these rules can manipulate the outgoing number before sending it out of this trunk
• ​Click the Submit button to save configuration